It's not heat that makes the set difficult to touch, but more than what I would like to feel emitting from a receiver cabinet. Soluzione: Provare a risaldare con saldatore ad aria calda, oppure utilizzare un fermaglio o altro sistema che tenga ben salda la giuntura del fleet Ho notato che la dissaldatura parte sempre da un lato iniziale del fleet. Almost like it is slightly rubbing on the case with half of the spin? It is not possible to select any bank number at random, but only one new bank. If the scanner encounters a signal strong enough to open the squelch, the scanner will halt and pause on that frequency. I have seen this other samples too so this is not a fault.
Not a problem with the lighting as the bright back light will not allow you to fall asleep in front of it. All are stinkers to my eyes but not a major drawback either. But it is a bit less than what I would like to see. If you try to change a value, but the enter key doesn't seem to work. Service bulletins refer to lot numbers. It's just that the procedure isn't explained very well in the manual, and often the manual is just plain wrong. Then follow the instruction below.
We have found no equal to this simple but excellent program. But it does take a bit getting used to selecting back and forth. This needs to be toggled off as it has no real use on shortwave. We can tune as fine as 20 Hz, which is very good on a set of this type. When you go to actually put real frequencies in those banks, just choose the channel number of the dummy frequency before you store your real frequency.
Before connecting the radio to the computer, read the manual updates, it is necessary to install the software and drivers required for the personal computer. You need to turn up the volume almost all the way to hear any signal at all. Display Gremlins, Main Knob, Tiny Tight Keyboard The display is nice and big with separate contrast and brightness controls. There have been many reports over the years where vertical parts of the dot matrix sections drop out, that is go missing. That is it takes 2 or 3 clicks to go one.
To keep any additional problems from creeping up, do not use a supply any lower than 13. It's a bit on the weak side for sure. For the amount of money this set sells for. In this case you can keep in memory if set to infinite the last snapshot of the bandscope before it was toggled off. But is still a bit on the light side no matter how you adjust it.
This is of course noticeable with the volume turned down, or squelched. More on this later, but just adds to the poor ergonomics. In my case it works as well as the autostore 1u. Its contrast while being adequate, could be better. So perhaps a case of spurious signal irking about? More background noise mixed in as well. It clears up some , but not all of the dynamic range problems on the main receiver.
With of course destroying the sensitivity. To reverse the direction of the scan i. I'm not the only person to have this problem, I read on the user groups that others are having almost the same lockup problems, and this is with firmware version ver. We are working every day to make sure our community is the best Radio Hobbyist's site. You can create as many banks as you want, but you can only access them one at a time.
Second tested sample never suffered from this bug firmware ver. Lets hope that this problem does not happen here? Again manual was of no help only saying a bit about this part of the band scope in one of the first pages of the manual. Solid steel top and bottom covers, as well as the rear. Sensitivity is also in the above average category. The downside is you are going to notice the sets nasty excessive hiss. This is the point that confuses people. But it can indeed be of use, as long as you know its limitations.
This allows the Channel Marker to be moved anywhere within the programmed sweep range. As an example, 0N070145 means December 2000, lot 7, unit 145. Also don't weight stress down the connector on the input of the attenuator with a thick cable. Connecting any large shortwave antenna will overload it for sure and makes it unacceptable. Scanning will resume according to the protocol you selected in the previous discussion. So for shortwave you are covered pretty much.